Thermistor 100K, Crimped w/ Cables – UltiMachine

4.5 (369) · $ 2.50 · In stock

This thermistor is used for measuring the temperature of the RepRap extruder. The thermistor has been crimped with wire leads and a 2-pin male latch housing. The matching cable has been housed with a 2-pin female latch housing on one end, and a 2-pin connector labeled "thermistor" on the other end. The default thermis

RAMPS 1.2 - RepRap

6*20mm 12V 40W 100K NTC Thermistor Wire 150mm PH2.0-2PIN Terminal for 3D Printer

Thermistor NTC 100K Wire 2m for 3D Printer

NTC 100K ohm B3950 Thermistor Cartridge

NTC 100K Thermistor with Bare Wire

RAMPS 1.4/ua - RepRap

HICTOP 100K ohm NTC 3950 Thermistors/Temp Sensor for Reprap Creality E - Hictop 3d printer

Trianglelab NTC 100K ohm B3950 Thermistor Cartridge Sensor High Temperature 280℃ for v6 PT100 V6 Heater Block 3D Printer

LulzBot Parts

Thermistor 100K NTC B3950 M3 Screw-In Style

RAMPS 1.4 알고 쓰자 : 네이버 블로그

Description3D Printer High-Temperature HT-NTC100K Thermistor Sensor With XH2.54 Terminal package contains of an accurate thermistor sensor with XH2.54