First Layer Issues - Creality K1 Max - 3D Printing Space

I’ve been all over the place with this machine so far, and this is where I am now. Any suggestions as to what direction I should be heading are appreciated. Rooted K1 Max/Orcaslicer/Duramic PLA/0.4mm nozzle @230⁰/speed: 50mm/retraction: 0.5mm @ 60mm second My starting flow ratio is 0.99 and my line width was at 0.34mm. I am playing with my Z offset and flow rate on the Fluidd interface as I go with these. The filament is dry. The flow settings shown on the pic are relative to the starting po

K1 max first layer problem : r/Creality

/files/html/20230615/212

Creality K1 Max Review: 3D Printer Testing

BAD First Layer Your K1 and K1 Max Printer? Here's how to get the best results.

K1 not doing first layer good anymore : r/Creality

Comprehensive Troubleshooting Guide for K1 Max 3D Printing Issues

Creality K1 Max Review: The 3D Printer of My Dreams Finally Exists

Creality K1 Max vs Bambu Lab X1 Carbon Comparison, 3D Printer Database

BAD First Layer Your K1 and K1 Max Printer? Here's how to get the best results.

K1 MAX Bad first layer - Ecosystem Product - Creality Community Forum

K1 max first layer problem : r/Creality

Creality K1 1.3.2.20 Firmware Update: Features, Enhancements, and User Guide
— Modern Makes

Bambu Lab P1S, 845.00 CHF

Creality K1 Max Fdm 3d Printer Corexy With 300x300x300mm Large Build Volume 600mm/s Printing Speed Large Flow Hotend - 3d Printer - AliExpress