Under-extrusion or gaps at seams with input shaper settings and 5
4.6 (692) · $ 26.00 · In stock
Page 2 | I have a mini+ but I think this issue might be on all Prusa printers with the recent input shaper enabled. Basically, there's ugly gaps at th
print quality - Under extrusion when starting outer wall - 3D Printing Stack Exchange
PEEI Sheet - surface peels off with prints lately? (PRUSAMENT PLA)?? – Hardware, firmware and software help – Prusa3D Forum
Underextrusion just around the holes, but near perfect print otherwise. Used calibrated Pressure Advance and 5mm retraction. What is the culprit? : r/klippers
Under-extrusion or gaps at seams with input shaper settings and 5.x firmware - Page 2 – Input Shaper (MINI) – Prusa3D Forum
Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum
Under-extrusion or gaps at seams with input shaper settings and 5.x firmware – Input Shaper (MINI) – Prusa3D Forum
underextrusion - Seams of print are underextruded causing large pits/gaps? (Prusa Mk3+, Prusa Slicer) - 3D Printing Stack Exchange
PEEI Sheet - surface peels off with prints lately? (PRUSAMENT PLA)?? – Hardware, firmware and software help – Prusa3D Forum
under-extrusion at seams? : r/BambuLab
Huge Gaps in my prints (possible Z-seams / infill issue?) : r/FixMyPrint
Under extrusion at the Z-seam : r/FixMyPrint
Under-extrusion (I think?) on one side of Z-Seam but not the other? : r/FixMyPrint
3D Printer Under-Extrusion: 8 Simple Solutions
Big gaps at z seam when using 0.8mm nozzle (underextrusion?) - General Discussion - Klipper