Input Shaper without effect?! - General Discussion - Klipper
5 (365) · $ 14.99 · In stock
Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement
Klipper: Input Shaping – Simply Explained
creating an input shaper tool out of a rpi pico : r/klippers
Help with input shaper - General Discussion - Klipper
I love Klipper and input shaping! I'm never going back to Marlin
Klipper: Input Shaping – Simply Explained
Input Shaper without effect?! - General Discussion - Klipper
Input Shaper without effect?! - General Discussion - Klipper
Sovol SV07 Plus 3D Printer with Klipper Firmware, Max Print Speed
Klipper input shaper wierd graph - General Discussion - Klipper
Klipper Resonance Compensation ( input shape ) does not make any
Support Center Raise 3D Technologies Inc
High Speed Printing: Your Options
FR] Alternative resonance testing methods with the ADXL345 · Issue
Input Shaper without effect?! - General Discussion - Klipper
Resonance Compensation - Klipper documentation